CE Certified Automatic Big Capacity Cleanroom Home Shoe Cover Dispenser

• Customization: Available
• Certification: CE
• Transport Package: 3kg
• Model NO.: E-SD-19
• Specification: 400pcs Shoe Cover
• Trademark: ECW
• Origin: China
• HS Code: 8477800000
• Production Capacity: 5000PC

Product Description

Clean-room Shoe Cover dispenser 
Specification:

Product name	Shoe cover machine
Input Voltage	110-220V
Adaptor Voltage	15V
Lithium Battery	12V 4500mA
Capacity	PE shoe cover 400pcs
size	23*35*13cm
Weight	3Kg
package (machine)	6pcs/ctn 58*41*57cm,19kg
package(shoe cover roll)	84roll/ctn, 58*41*57cm,26.2kg

Attention:
The shoe charger cannot be used when it is charging, please remove the charger before use.

Using Steps 

a. Let heel step between the shoe film support plate, and the heel bottom touch the machine surface, let the shoes film cover the heel a little high, so that it will not fall off easily.
Attention:
Heel bottom must touch the machine surface
Shoe tip against the front of the pedal
b. Pull back, until the shoe tip against the front of the pedal, step on the switch for 0.5 seconds, then machine works
Attention:
Please don't pull too long, otherwise the shoe won't be wrapped tight. 
Raise the foot hell.
c. Sealing clamp clamps the shoe film seal and    cuts it off. If the shoe film was not completely cut off after the sealing clamp opened. Please pull it backwards to disconnect. The entire shoe wrapping process is completed.
Attention:
When pressing the foot switch, please raise the foot heel a little, so that the film will cover better and the seal is not easy to open.

4. Shoe Film Installation Method
a. Lift up the upper cap, pry back with thumb to open the back cap.
b. Take out the film shaft and put into the shoe film.
c. Place one end of the film shaft diagonally into the film holder hole, then push the other end in.
Attention! 
The shoe film cover the shoe, elastic bands must be outside the film. If elastic bands inside the film, Take off the shoe film and change direction to install.
d. Place the shoe film support plate on the shoe film and pull the shoe film over the machine
e. Pull the shoe film straight and ensure that both sides are symmetrical. Lift up the hand which is pulling film slightly. Push the signal switch with the other hand for 0.5 seconds, then cut off the wrinkled shoe film.
f. After cut off, the shoe film seal must be erected before use
5. Charging Method
a. Plug the charger into AC power socket.
b. Plug the connector plug of charger into the charging inlet of machine.
Attention:
When charging, please make sure the host's power switch is turned on.
After charging is finished, please unplug the charger promptly.
The host indicator lights red when the product is charging, and it lights green when charging is completed.
If indicator light flashes red when using, it indicates that the battery is running low and needs to be charged.
If indicator light flashes green when using, it indicates that the battery is completely used up and must be charged before using.

6. Maintenance
Before cleaning the product, please turn off the power switch(on-off) first.
The product surface could not be scrubbed with gasoline or oily materials. Please scrub it with water or neutral detergent. Before scrubbing, be sure to wring the cloth to dry first, and do not allow water to infiltrate inside the machine.
Before use, check whether there is any foreign matter on the sealing clamp. Please clean the foreign matter before use, keep the self-adhesive pad on bottom of the machine clean. Otherwise, the self-adhesive pad will not stick to the floor and it will be easy to pull.
If the product will not be used for a long time, please turn off the power switch(on-off) and put into packing box, place it in a dry place to avoid moisture.